We often get questions from our art print shop customers about the best way to frame a rolled canvas, especially when they want to avoid the traditional method of stretching and using a floater frame. For those looking for a beautiful, vintage-inspired alternative, framing a rolled canvas with a vintage frame is a fantastic option. Here’s a step-by-step guide on how to do it using foam board, spray adhesive, tape, and a few other supplies.
Supplies You’ll Need:
- Vintage frame
- Rolled canvas
- Foam board
- Spray adhesive
- Brown packing tape
- Craft or utility knife
- Ruler
- Pencil
- Paper (for backing)
- Saw tooth hanger
- Hammer
- Utility knife
Measure and Cut the Foam Board
Start by measuring the inside dimensions of the vintage frame with your ruler. Once you have the measurements, transfer them to the foam board, marking where you need to cut with a pencil. Carefully cut along the lines with your craft or utility knife to ensure a snug fit inside the frame.
Prepare the Canvas
Unroll the canvas and lay it flat on a clean surface. It should fit the trimmed foam board. So if it is a little too big, use the utility knife to trim the edges.
Attach the Canvas to the Foam Board
In a well-ventilated area, lightly spray the adhesive onto the foam board, making sure to cover the entire surface evenly. Carefully place the canvas on the foam board, starting from one edge and smoothing it down to avoid bubbles or wrinkles. Press down firmly to ensure good adhesion.
Fit the Canvas into the Frame
Place the foam board with the canvas attached into the vintage frame. It should fit snugly. To secure it in place, apply a piece of tape to all four sides.
Finish the Back of the Frame
This step isn’t required, but it does give the back of your framed art a more finished look.
Cut a piece of paper slightly larger than the frame to cover the back and give it a finished look. Use the spray adhesive or double-sided tape to attach the paper to the back of the frame. Trim any excess paper with scissors for a clean edge.
Add the Saw Tooth Hanger
Measure and mark the center point on the top edge of the frame. Place the saw tooth hanger on the marked spot and secure it with the small nails provided. Use a hammer to gently tap the nails into place.
Final Touches
Inspect your work to make sure the canvas is smooth and centered within the frame. Check that the backing paper is securely attached and the saw tooth hanger is firmly in place. Find the perfect spot on your wall and hang your newly framed canvas. Step back and admire your handiwork!
No Comments